We Accept Visa, MasterCard and Debit Cards
AUTO & TRUCK REPAIR
Lube, Oil, Filter Procedure and Checklist
The following list details all of the procedures Performance Concepts Iowa checks off for each lube/oil/filter service we provide.
- Fill out all information on work order.
- Set car on lift.
- Check condition of wiper blades — replace if needed.
- Test all lights for correct operation and replace as needed — test again.
- Inspect condition of belts and hoses.
- Remove air filter — replace if needed. Check cabin filter if vehicle is equipped with one.
- Raise car about half way and check for play in all 4 wheels.
- Remove wheels.
- Check condition of brakes.
- Raise car and drain oil from engine.
- Remove oil filter and allow to drain.
- Inspect underside of vehicle for leaks, loose brackets, exhaust leaks, and note any problems.
- Install oil pan drain plug and new oil filter. Check drain plug gasket and replace if needed. Check for oil filter gasket on old filter.
- Clean any excess oil off the vehicle.
- Lubricate chassis if grease fittings are present. Lubricate door hinges.
- Lower vehicle about halfway.
- Rotate tires and set pressures. (Cross drive wheels and move non drive wheels straight to drive. Check for directional tires and different size tires.)
- Install wheels so they are snug or hand tight.
- Lower vehicle enough so wheels will not move and torque wheels to manufacturer’s recommendation.
- Fill engine to correct level with recommended oil.
- Start vehicle and run for 30 seconds. Turn engine off. Check engine oil level, and if necessary, correct level.
- Check for leaks around oil filter and drain plug.
- Check the following fluids and add as needed:
- Coolant
- Brake fluid
- Transmission fluid — following manufactures recommended procedures
- Windshield washer fluid
- Power steering fluid
- Check battery and battery terminals for connection tightness and corrosion.
- Make sure that handprints are wiped clean and interior has been checked for any handprints, dirt, etc. Wipe down as needed.
- Place reminder date sticker in upper left hand corner of windshield.
- Remove vehicle from lift and bring work order form to front desk. Make sure all part, filters, belts, hoses, and bulbs are listed on the form.
- Prepare estimate for all recommended repairs.